Program-A-Swirl®
 

Dispenses Circular Patterns, Continuous Bead or
Sound Deadener up to 150mm wide in only ONE pass

By dispensing in a swirled pattern of closed loops, the Program-A-Swirl® maximizes adhesion between two substrates and uses less material to 'wet out' a greater area. Swirling is achieved when the servo motor spins the system’s nozzle. When the servo motor stops, the nozzle “self-centers,” allowing the tool to alternate on-the-fly between swirling patterns and dispensing beads.
 



 

 

 

 

 

 

 

 

 

 

Single Component
Program-A-Swirl®
 

 The versatile Program-A-Swirl® system is available in two styles.

One can be used with a special disposable dynamic mixer nozzle for two-component, reactive-resin materials (see right).  The mixer nozzle has a self closing nozzle tip.

The other version is designed to dispense single-component materials (see left).

Program-A-Swirl® is typically mounted as an end-of-arm tool in robotic applications, or fixture-mounted in automation tooling.

Program-A-Swirl®'s dispensing patterns will meet the geometry of virtually any application requirement, precisely adjusting the size of the looped pattern or bead.

 

 

 

 

 

 

 

 

 

 

 

Two Component
Program-A-Swirl®

For best results it is recommended that you use a metering system such as the SeeFlo®, SeeBead®, or Program-A-Bead® which are designed to provide a precise material flow to the applicator head.

PATENTS PENDING


 


 

Typical Swirl trace into a straight showing self centering bead on
second pass

Close-up of swirl pattern which was followed by a bead on the second pass, hereby showing the effectiveness
of the self centering ability
of the Program-A-Swirl®

 

Typical Swirl trace into a corner showing self centering bead on second pass
 

 

Example of a single pass with Program-A-Swirl®
applying sound deadening in 150mm width band

Short video presentation of the
Program-A-Swirl® in action

 Video footage of Swirl Attachment in action

 

Top of Page